В работе была выполнена систематизация подходов инъекционного закрепления грунтов с акцентом на геополимерные составы для структурно неустойчивых оснований. Проведён хронологический обзор эволюции методов от цементации и силикатизации к геополимерному инъектированию, уточнены нормативно-технические рамки применения в контексте проектирования оснований и контроля качества работ. Были проанализированы составообразующие факторы геополимерных систем (тип алюмосиликатного сырья, модуль щёлочности, водотвёрдое отношение), влияющие на реологию и кинетику структурообразования при нагнетании, и сопоставлена инженерная результативность с традиционными цементными растворами по признакам снижения фильтрационной способности массива и роста деформационной жёсткости. Был проведен сравнительный анализ с методом силикатизации. По итогам исследования были сформулированы выводы о технологической реализуемости и нормативной верифицируемости геополимерного инъектирования в задачах реконструкции оснований, а также обозначены направления стандартизации рецептур и полевых испытаний для включения метода в типовые решения.
The paper systematized the approaches of injection soil fixation with an emphasis on geopolymer compositions for structurally unstable bases. A chronological review of the evolution of methods from cementation and silicatization to geopolymer injection has been carried out, and the regulatory and technical scope of application in the context of base design and quality control has been clarified. The composition-forming factors of geopolymer systems (the type of alumosilicate raw materials, the alkalinity modulus, and the water-solid ratio) affecting the rheology and kinetics of structure formation during injection were analyzed, and engineering performance was compared with traditional cement mortars based on signs of a decrease in the filtration capacity of the array and an increase in strain stiffness. A comparative analysis with the method of silicatization was carried out. Based on the results of the study, conclusions were formulated on the technological feasibility and regulatory verifiability of geopolymer injection in the tasks of base reconstruction, as well as directions for standardization of formulations and field tests for including the method in standard solutions.